Kia Sorento: Passenger Airbag (PAB) Removal and Installation

Removal

Disconnect the battery negative ( - ) terminal.

After disconnecting the battery negative ( - ) terminal, wait at least 3 minutes and 30 seconds.

2.	Remove the main crash pad assembly. (Refer to Body - "Main Crash Pad Assembly")

3.	Remove the air vent duct connector assembly (A) after removing the screw.

Remove the passenger airbag (A) after removing the bolts and screws.

Tightening torque :

3.9 - 5.9 N·m (0.4 - 0.6 kgf·m, 2.9 - 4.3 lb·ft, 34.7 - 52.1 lb·in)

Restraint — Airbag Module / Passenger Airbag (PAB) / Removal and Installation / Removal illustration

Installation

1.	Install in the reverse order of removal.

Check that the airbag system operates normally.

When the IG is on, the airbag warning lamp should turns off after turning on for 3 - 6 seconds.

Passenger Airbag (PAB) On Vehicle Inspection On Vehicle Inspection Diagnostic with KDS 1. The passenger...

Center Side Airbag (CSAB) On Vehicle Inspection On Vehicle Inspection Diagnostic with KDS 1. The center...

Manuals list