Kia Sorento: Input Speed Sensor Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Input Speed Sensor Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor Removal

1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed sensor connector (A).
3.
Remove the input & output speed sensor (B) after removing the bolts (2ea).

Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Input Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification : Refer to "Signal Wave Form" section. ...

Input Speed Sensor Installation
1. Install in the reverse order of removal.    • ...

See also:

Circuit Diagram
...

Direct Electro Hydraulic Actuator Coupling Description
4WD ECU processes signals from various sensors and determines the current road and driving conditions. The ECU then utilizes this information to implement precision control over the 4WD coupl ...

Power Seat Control Switch Inspection
1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat ...

Copyright www.ksmanual.com 2014-2026