Kia Sorento: Heated Oxygen Sensor (HO2S) Specifications. Heated Oxygen Sensor (HO2S) Description and Operation - Engine Control System - Engine Control / Fuel SystemKia Sorento: Heated Oxygen Sensor (HO2S) Specifications. Heated Oxygen Sensor (HO2S) Description and Operation

Kia Sorento (MQ4, 2021-2026) Service Manual / Engine Control / Fuel System / Engine Control System / Heated Oxygen Sensor (HO2S) Specifications. Heated Oxygen Sensor (HO2S) Description and Operation

Heated Oxygen Sensor (HO2S) Specifications

Specification
Item
Specification
Remark
Heater resistance (Ω)
Front
2.8 - 4.5
18 - 28°C (64.4 - 82.4°F)
Rear
5.4 - 6.6

Heated Oxygen Sensor (HO2S) Description and Operation

Description
•
Heated Oxygen Sensor (HO2S), consisting of zirconium and alumina, is installed on both upstream and downstream of the Manifold Catalytic Converter (MCC) to detect the air/fuel ratio and send it to the Engine Control Module (ECM).
•
In order that this sensor operates properly, the temperature of the sensor tip must be higher than 370°C (698°F).
For this reason, a heater controlled by the ECM duty signal, is built into the sensor.
•
When the exhaust gas temperature is lower than the specified value, the heater warms the sensor tip.
Front Heated Oxygen Sensor

Engine Control / Fuel System — Engine Control System / Heated Oxygen Sensor (HO2S) / Description and Operation / Description illustration

Rear Heated Oxygen Sensor

Engine Control / Fuel System — Engine Control System / Heated Oxygen Sensor (HO2S) / Description and Operation / Description illustration

ETC (Electronic Throttle Control) System Cleaning
Cleaning 1. Remove the Electronic Throttle Control (ETC). (Refer to ETC (Electronic Throttle Control) System - "Removal and I...
Heated Oxygen Sensor (HO2S) On Vehicle Inspection
On Vehicle Inspection 1. The engine control system can be more quickly diagnosed for problems with the KDS. (Refer to "DTC guide") ...
See also:

Description
Intake Air Temperature Sensor (IATS) is included inside Manifold Absolute Pressure Sensor and detects the intake air temperature. To calculate precise air quantity, correction of the air tem ...

Fuel Filler Door Open Switch Inspection
1. Remove the front door trim panel. (Refer to Body - "Front door") 2. Disconnect the switch connector (A) from wiring. ...

Rear Console Cover Repair Procedures
Removal 1. Remove the floor console assembly. (Refer to Floor Console - "Floor Console Assembly") ...

Copyright © www.ksmanual.com 2014-2026 - 0.0527