Kia Optima Manuals

Kia Sorento: Front Bumper Replacement - Bumper - Body (Interior and Exterior) - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Front Bumper Replacement

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body (Interior and Exterior) / Bumper / Front Bumper Replacement

  
•
Pry the trim off using a plastic trim tool and apply protective tape around the related parts, to prevent damage.
•
Put on gloves to protect your hands.
•
Take care not to scratch the body surface.
1.
Loosen the radiator upper cover mounting bolts and clips.
2.
Loosen the front bumper lower mounting clips.
3.
After loosening the front bumper side's mounting screw, then disconnect the side's.
4.
Disconnect the fog lamp connector (A).
[LH]

[RH]
5.
Remove the front bumper cover (A).
6.
Install in the reverse order of removal.
  
•
Make sure the connector is connected properly.
•
Replace any damaged clips.
Front Bumper Components
1. Front bumper cover 2. Front bumper lower stiffner 3. Front bumper upper stiffner 4. Front bumper side bracket ...

Rear Bumper Components
1. Rear bumper cover 2. Rear bumper lower bracket [RH] 3. Rear bumper lower bracket [LH] 4. Rear bumper side bracket [RH] 5. Rear bumper side bracket [LH] ...

See also:

Flex Steering Circuit Diagram
...

Panorama Sunroof Motor Replacement
Resetting The Panoramaroof Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the panoramaroof, you have to reset your panoramaroof sys ...

Heated Oxygen Sensor (HO2S)
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance ...

Categories

Copyright www.ksmanual.com 2014-2026