Kia Sorento: Fog Lamp Repair Procedures

Removal

Front fog lamp

1.	Remove the front bumper assembly. (Refer to Body - "Front Bumper Assembly")

2.	Disconnect the fog lamp connector (A).

3.	Remove the fog lamp assembly (A) after removing the screws.

Rear fog lamp

1.	Remove the rear bumper beam assembly. (Refer to Body - "Rear Bumper Assembly")

2.	Disconnect the fog lamp connectors (A).

3.	Remove the fog lamp (A) after removing the screws.

Installation

Install in the reverse order of removal.

If the fog lamp needs to be adjusted, refer to fog lamp aiming point procedure.

(Refer to Fog Lamp - "Adjustment")

Adjustment

Fog Lamp Aiming

Alternately turn the adjusting gear to adjust the fog lamp aiming. If beam-setting equipment is not available, proceed as follows.

1.	Inflate the tires to the specified pressure and remove any loads from the vehicle except the driver, spare tire, coolant, fuel, and tools.

2.	The vehicle should be placed on a flat floor.

3.	Check if there is something wrong with the suspension spring.

4.	Clean the headlamp lens.

5.	Draw vertical lines (Vertical lines passing through respective fog lamps centers) and a horizontal line (Horizontal line passing through center of fog lamps) on the screen.

6.	Align the focus of the fog lights with the battery in normal condition. Adjust the adjustment bolt (A) to the specified value.

Fog Lamp Aiming Point

Aiming Point

Body Electrical System — Lighting System / Fog Lamp / Repair Procedures / Adjustment illustration

H : Height between the fog lamp center and ground

W : Distance between the fog lamp center

1.	Turn the front fog lamp on without the driver aboard.

2.	The cut-off line should be projected in the allowable range (shaded region).

Removal 1. Disconnect the battery negative ( - ) terminal. 2. Remove the cargo lamp lens (A). ...

Removal 1. Disconnect the battery negative ( - ) terminal. 2. Remove the glove box lamp (A). ...

Manuals list