Kia Sorento: Filler-Neck Assembly Removal - Fuel Delivery System - Engine Control / Fuel System - Kia Sorento XM 2011-2025 Service ManualKia Sorento: Filler-Neck Assembly Removal

Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Filler-Neck Assembly Removal

1.
Lift the vehicle.
2.
Disconnect the fuel filler hose (A).
3.
Disconnect the ventilation tube quick-connector ( B).

4.
Open the fuel filler door and unfasten the filler-neck assembly mounting screw (A).

5.
Remove the rear-LH wheel, tire and the inner wheel house.
6.
Remove the filler-neck assembly from the vehicle after removing the bracket mounting nut (A).

Fuel Line Installation
1. Install in the reverse order of removal. ...

Filler-Neck Assembly Installation
1. Install in the reverse order of removal. Filler-neck assembly bracket installation nut : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ ...

See also:

Troubleshooting
   • The battery must be in good condition and fully charged for this troubleshooting. ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS)
Overdrive clutch control solenoid valve(OD/C) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the overdrive clutch. ...

ESC Control Module Removal
1. Turn the ignition switch OFF. 2. Remove the surge tank. [G3.3 GDI] (Refer to Engine Mechanical System - "Surge Tank") ...

Copyright В© www.ksmanual.com 2014-2025