Kia Sorento: Engine Control Module (ECM) Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Control Module (ECM) Removal

1.	Turn ignition switch OFF and disconnect the negative (-) battery cable.

2.	Disconnect the ECM Connector (A).

3.	Remove the battery. (Refer to Engine Electrical System - "Battery")

4.	Remove the air cleaner assembly. (Refer to Engine Mechanical System - "Air Cleaner")

5.	Remove the mounting bolt (A) and nuts (B), and then remove the ECM (C).

6.	After romoving the installation nuts (A) and screws (B), romove the ECM (C) from the bracket.

Engine Control Module (ECM) Circuit Diagram

...

Engine Control Module (ECM) Installation

1. Install in the reverse order of removal. ECM installation bolt: 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m,7.2 ~ 8.7 lb-ft) ECM ...

See also:

Specifications
Direct control VFS[UD/B] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 539.370 ~ 0 ( 5.5 ~ 0, 78.23 ~ 0) Current value(mA) ...

Cylinder Block Inspection
1. Remove gasket material. Using a gasket scraper, remove all the gasket material from the top surface of the cylinder block. 2. Cl ...

Front Door Components
1. Door grip handle cover 2. Door inside handle cap 3. Door trim 4. Door belt inner weatherstrip 5. Door module 6. Quadrant inner cover 7. Door belt weatherstrip 8. ...

Categories

Copyright © www.ksmanual.com 2014-2026