Kia Sorento: Components and Components Location. Cluster Support Bracket Repair Procedures - Crash Pad - Body (Interior and Exterior)Kia Sorento: Components and Components Location. Cluster Support Bracket Repair Procedures

Kia Sorento (MQ4, 2021-2026) Service Manual / Body (Interior and Exterior) / Crash Pad / Components and Components Location. Cluster Support Bracket Repair Procedures

Components and Components Location

Component

Body (Interior and Exterior) — Crash Pad / Components and Components Location / Component illustration

1. Glove Box
2. Crash Pad Under Cover
3. Center Speaker Grille
4. Rear Display Cover
5. Integrated Monitor
6. Driver's Side Crash Pad Side Cover
7. Passenger's Side Crash Pad Side Cover
8. Driver's Side Crash Pad Garnish
9. Passenger's Side Crash Pad Garnish
10. Steering Column Upper Shroud Panel
11. Steering Column Lower Shroud Panel
12. Cluster Support Bracket
13. Infotainment Keyboard
14. Crash Pad Lower Panel
15. Crash Pad Switch Panel
16. Crash Pad Center Panel
17. Crash Pad Assembly
18. Crash Pad Duct Assembly
19. Cowl Cross Bar Assembly

Cluster Support Bracket Repair Procedures

Removal
1.
Remove the steering column shroud upper panel.
(Refer to Crash Pad -"Steering Column Shroud Panel")
2.
Remove the cluster support bracket (A) after removing the screws.

Body (Interior and Exterior) — Crash Pad / Cluster Support Bracket / Repair Procedures / Removal illustration

Body (Interior and Exterior) — Crash Pad / Cluster Support Bracket / Repair Procedures / Removal illustration

Information
Clip position :

Body (Interior and Exterior) — Crash Pad / Cluster Support Bracket / Repair Procedures / Removal illustration

Installation
1.
Install in the reverse order of removal.
Crash Pad
...
Crash Pad Lower Panel Repair Procedures
Removal 1. Disconnect the battery negative ( - ) terminal. 2. Remove the crash pad side cover [D...
See also:

Tire sidewall labeling
This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be used ...

Shift Lever Components and Components Location
Component 1. Manual Lever Assembly1-a. 8.8 - 13.7 N·m (0.9 - 1.4 kgf·m, 6.5 - 10.1 lb·ft) 2. Snap Pin3. Shift Cable Ass ...

Removal
1. Remove the tailgate trim in the trunk after removing the screws and clips. (Refer to Body - "Tailgate") 2. Remove the ...

Copyright © www.ksmanual.com 2014-2026 - 0.0795