Kia Optima Manuals

Kia Sorento: Battery Description and Operation - Charging System - Engine Electrical SystemKia Sorento: Battery Description and Operation

Kia Sorento (MQ4, 2021-2026) Service Manual / Engine Electrical System / Charging System / Battery Description and Operation

Description
Battery Label Information

Engine Electrical System — Charging System / Battery / Description and Operation / Description illustration

1.
Battery Type
- AGM : Absorbent Glass Material
- MF : Maintenance Free
- CMF : Closed Maintenance Free
2.
Battery Capacity (20 HR)
3.
Positive ( + ) Terminal Location
- L : Left
- R : Right
4.
Battery Terminal Type
- DIN (Deutsche Industric Normen) : Recessed terminal
- BCI (Battery Council International) : Intruding terminal
5.
Cold Cranking Ampere (CCA)
Information
•
Cold Cranking Ampere (CCA): CCA is a rating used in the battery industry to define a battery's ability to start an engine in cold temperatures.
•
The rating is the number of amps a new, fully charged battery can deliver at -18 °C (-0.4 °F) for 30 seconds, while maintaining a voltage of at least 7.2 V for a 12 V battery.
•
The higher the CCA rating, the greater the starting power of the battery.
6.
Part Number
7.
Reserve Capacity (RC)
Information
•
RC is a battery industry rating, defining a battery's ability to power a vehicle with an inoperative alternator or fan belt.
•
The rating is the number of minutes a battery at 26.7 °C (80 °F) can be discharged at 25 amps and maintain a voltage of 10.5 V for a 12 V battery.
•
The higher the reserve rating, the longer your vehicle can operate should your alternator or fan belt fail.
Absorbent Glass Material (AGM) Battery
•
Absorbent Glass Material (AGM) battery is used for especially heavy load on the vehicle network depending on equipment and requirements.
•
The AGM battery is mainly applied to Idle stop & Go (ISG) vehicles as it has excellent durability despite high load on frequent charging and discharging.
Battery Specifications
Specification Item Specification Model type AGM70L-DIN Capacity [5 ...
Battery On Vehicle Inspection
On Vehicle Inspection Battery voltage and status Check the battery voltage and status by using a battery tester. Battery terminal 1. Move back and ...
See also:

Water pump Repair procedures
Removal and Installation 1. Disconnect the battery negative ( - ) terminal. 2. ...

Specification
Tightening Torque Tightening Torque Interior Trim Center Pillar Lower Trim Item N·m kgf·m ...

On Vehicle Inspection. Adjustment
On Vehicle Inspection On Vehicle Inspection Diagnostic With KDS 1. The body electrical system driving ...

Manuals list

Copyright © www.ksmanual.com 2014-2026 - 0.0692