Kia Sorento: Auto Light Switch Inspection - Auto Lighting Control System - Body Electrical System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Auto Light Switch Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Switch Inspection

Operate the auto light switch, then check for continuity between terminals of multi-function switch connector.

Circuit Diagram
...

Auto Light Sensor Inspection
In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor ...

See also:

Blind Spot Detection Switch Circuit Diagram
...

Intake Actuator Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the cowl side trim. (Refer to Body - "Crash Pad") ...

Front Fog Lamps Inspection
1. With the fog lamp switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the multifunctio ...

Copyright www.ksmanual.com 2014-2026