Kia Sorento: Auto Light Sensor Removal - Auto Lighting Control System - Body Electrical System - Kia Sorento XM 2011-2023 Service ManualKia Sorento: Auto Light Sensor Removal

Second Generation XM (2011-2023) / Kia Sorento XM 2011-2023 Service Manual / Body Electrical System / Auto Lighting Control System / Auto Light Sensor Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the photo & auto light sensor (A) from crash pad upper side by using screw (-) driver.

3.
Remove the auto light connector.
Auto Light Sensor Inspection
In the state of IGN1 ON, when multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light sensor ...

Auto Light Sensor Installation
1. Reconnect the auto light connector. 2. Install the auto light sensor. ...

See also:

Emergency Fastening Device (EFD) Removal
1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the EFD cover pad (A). ...

On-vehicle Inspection
Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.    ...

Rear combination lamp Installation
1. Install the tailgate combination lamp assembly after replacing the bulb. 2. Install the lamp cover to the tailgate after connecting the ...

Copyright В© www.ksmanual.com 2014-2023