Kia Sorento: Antenna Repair Procedures - Infotainment System - Body Electrical SystemKia Sorento: Antenna Repair Procedures

Kia Sorento (MQ4, 2021-2026) Service Manual / Body Electrical System / Infotainment System / Antenna Repair Procedures

Removal
Roof Antenna
1.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim Assembly")
2.
Disconnect the roof antenna connector (A).
3.
Remove the roof antenna (C) after removing the nut (B).

Tightening torque :
7.8 - 11.8 N·m (0.8 - 1.2 kgf·m, 5.8 - 8.7 lb·ft)

Body Electrical System — Infotainment System / Antenna / Repair Procedures / Removal illustration

Body Electrical System — Infotainment System / Antenna / Repair Procedures / Removal illustration

Crash Pad Antenna
1.
Remove the Connected Car Navigation Cockpit (ccNC).
(Refer to Infotainment System - "Connected Car Navigation Cockpit (ccNC)")
2.
Remove the cluster unit.
(Refer to Indicators And Gauges - "Cluster Unit")
3.
Remove the crash pad antenna (A) after removing the screws.

Body Electrical System — Infotainment System / Antenna / Repair Procedures / Removal illustration

4.
Disconnect the crash pad antenna connector (A).

Body Electrical System — Infotainment System / Antenna / Repair Procedures / Removal illustration

5.
Remove the crash pad antenna wiring clip.

Body Electrical System — Infotainment System / Antenna / Repair Procedures / Removal illustration

Installation
1.
Install in the reverse order of removal.
Infotainment System
...
Connected Car Navigation Cockpit (ccNC) Components and Components Location. Connected Car Navigation Cockpit (ccNC) On Vehicle Inspection
Connected Car Navigation Cockpit (ccNC) Components and Components Location Component 1. Driver's side Crash Pad Side Cover2. Passenge...
See also:

Rear Assist Arm Removal
1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

Rear Wheel Speed Sensor Components
1. Rear wheel speed sensor 2. Rear wheel speed sensor cable ...

Power Seat Control Switch Inspection
1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat ...

Copyright © www.ksmanual.com 2014-2026 - 0.0575