Be sure to install the harness wires not to be pinched or interfered
with other parts.
|
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
|
3. |
Install the seatbelt buckle & buckle switch.
|
4. |
Install the front seat assembly. . (Refer to the Body group- Front
seat)
|
5. |
Reconnect the battery negative cable.
|
6. |
After installing the seat belt buckle switch, confirm proper system
operation:
|
Parking Brake Lever Assembly Installation
1.
Install the parking brake lever assembly (A).
Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
...
LCD Modes
Trip Computer
This mode displays driving information like the tripmeter, fuel economy, and
so on.
Service
This mode informs of service interval (mileage or days) and warning mess ...
Signal Waveform
The three waveforms below are taken from the #1 and #4 injectors. The
top waveform is from the high side (feed side) of the #1 and #4 injectors, while
the middle waveform is from the low side ...