1. |
Remove the rear wheel and tire (A) from rear hub .
|
2. |
Support the rear lower arm (A) with a jack as shown in the illustration.
|
3. |
Remove the spring (A), the upper pad (B) and the lower pad (C).
|
4. |
Installation is the reverse of removal.
|
5. |
Check the wheel Alignment.
(Refer to Tires/Wheels - "Alignment")
|
Specification
Item
Specification
Coil Resistance (Ω)
19.0 ~ 22.0 [20°C(68°F)]
...
Crankshaft Damper Pulley Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
2.
Remove the passenger engine room side cover.
(Ref ...
Fuel Line Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to the F ...