1. Knuckle 2. Dust cover |
3. Hub assembly 4. Brake disc |
Replacement
The injector combustion seal should be replaced new one to prevent leakage
after removing the injector.
1.
Remove the combustion seal (A) with a wire cutter.
...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Rear Disc Brake Replacement
1.
Remove the rear wheel & tire.
2.
Loosen the guide rod bolt (B) and pivot the caliper (A) up out
of the way.
...