1. |
Disconnect the negative (-) battery terminal.
|
2. |
Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver
then replace the bulb.
|
3. |
Loosen the fixing screw (2EA) and disconnect the 4P connector.
And then remove the room lamp assembly (A).
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Detach the lamp lens (A) from the room lamp with a flat-tip screwdriver
then replace the bulb (B).
|
3. |
If it is necessary to replace the lamp assembly, remove the room
lamp (A).
|
Inspection
•
Thoroughly check connectors for looseness, poor connection,
bending, corrosion, cont ...
Rear Assist Arm Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the rear assist arm for deformation.
...
Adjustment
After replacing ETC module or ECM, the ETC adaptive value must be reset
/ relearned according to the following procedure.
1.
Check DTC(s) and clear if exist.
...