1. |
Disconnect the negative battery terminal.
|
2. |
Remove the front door trim.
(Refer to Body - "Front door")
|
3. |
Remve the screws(Inside:4EA, outside:1EA) from door module (A)
and connectors (B).
|
4. |
Remove the driver door module (A) from front door trim.
|
Description
The Electronic Throttle Control (ETC) System consists of a throttle body
with an integrated control motor and throttle position sensor (TPS). Instead
of the traditional throttle cable, an Acc ...
Rear Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Rear Wiper Switch
Rear Washer Swi ...
Blower Resistor Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...