Kia Sorento: 28 Brake Control Solenoid Valve (28/B_VFS) Installation
|
•
|
Check the oil pressure characteristics value (A) at the first before installing the solenoid valve.
|
|
•
|
If incorrect hydraulic characteristics are entered, the shift impact may occur during TCM learning,
so note the engraved hydraulic values carefully.
|
|
| 1. |
Install in the reverse order of removal.
|
The existing valve body cover gasket (A) must be replaced with a new one (do not reuse).
|
|
| 2. |
Perform the procedures below after installing.
| (1)
|
Refill the automatic transaxle with fluid.
(Refer to Hydraulic System - "Fluid")
|
After ATF injection and level check, clean ATF outside the automatic transaxle.
(Wipe off the residual ATF, especially between the automatic transaxle case and the valve
body cover.)
|
|
| (2)
|
Refill the engine coolant.
(Refer to Engine Mechanical System - "Coolant")
|
| (3)
|
Clear the diagnostic trouble codes (DTC) using the KDS. Disconnecting the battery negative terminal
will not clear the DTCs. Clear DTCs using the KDS at all times.
|
| (4)
|
Perform the resetting automatic transaxle adaptive values using the KDS.
(S/W Management → Automatic Transaxle → Resetting Auto T/A Values)
|
Refer to the KDS screen for operating conditions and details.
|
|
| (5)
|
Perform the oil pressure characteristics input procedure using the KDS.
(S/W Management → Automatic Transaxle → Oil-pressure Characteristics Input(Solenoid Valve
Replacement))
|
Refer to the KDS screen for operating conditions and details.
|
|
| (6)
|
Perform the TCM adaptive values learning procedure.
(Refer to Automatic Transaxle Control System -
"Adjustment")
|
| (7)
|
After installing, check for leakage of fluid from hose connection during engine starting and
running.
|
|
UD Clutch Control Solenoid Valve (UD/C_VFS) Specifications
Specification
Item
Specification
Control type
N/L (Normal ...
28 Brake Control Solenoid Valve (28/B_VFS) Removal
UD Clutch Control Solenoid Valve (UD/C_VFS) Specifications. UD Clutch Control Solenoid Valve (UD/C_VFS) Components and Components Location
