Kia Sorento: Windshield Glass Removal - Exterior - Body (Interior and Exterior) - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Windshield Glass Removal

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Body (Interior and Exterior) / Exterior / Windshield Glass Removal

  
Х
Put on gloves to protect your hands.
Х
Use seat covers to avoid damaging any surfaces.
1.
Remove the following parts.
A.
Front pillar trim
B.
Inside rear view mirror
C.
Rain sensor
(Refer to "Rain Sensor" in BE group)
D.
LDWS unit
(Refer to "LDWS Unit" in BE group)
E.
Auto defog sensor
(Refer to "Auto Defog Sensor " in HA group)
F.
Wiper arm
G.
Cowl top cover
H.
Windshield glass deicer connector
(Refer to "Windshield Deicer" in BE group)
2.
Using a screwdriver or remover, remove the windshield moulding (A).

3.
Cut out the sealant using the sealant cutting tool (09861-31100).

4.
Remove the windshield glass (B) carefully using the glass holder (A).

Windshield Glass Components
1. Windshield side moulding 2. Windshield glass ...

Windshield Glass Installtion
1. With a knife, scrape the old adhesive smooth to a thickness of about 2mm (0.08 in.) on the bonding surface around the entire windshield opening flange : ...

See also:

Interior A
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

Emergency starting
Connect cables in numerical order and disconnect in reverse order. Jump starting Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehicle ...

Mode Control Actuator Description
The mode control actuator is located at the heater unit. It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing ...

Copyright © www.ksmanual.com 2014-2019