Kia Sorento: Temperature Control Actuator Description - Heater - Heating,Ventilation And Air Conditioning - Kia Sorento XM 2011-2021 Service ManualKia Sorento: Temperature Control Actuator Description

Second Generation XM (2011-2021) / Kia Sorento XM 2011-2021 Service Manual / Heating,Ventilation And Air Conditioning / Heater / Temperature Control Actuator Description

The heater unit includes mode control actuator and temperature control actuator.
The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.
Signal from control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temperature door.
Evaporator Core Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") ...

Temperature Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the t ...

See also:

TJ Joint Components
[LH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly 9. Retainer ring 10. ...

Fuse/relay panel description
Inside the fuse/relay panel covers, you can find the fuse/relay label describing fuse/relay name and capacity. ✽ NOTICE Not all fuse panel descriptions in this manual may be applicable to ...

Special Tools
Tool (Number and name) Illustration Use 09977-3R000 Disc & hub assembly bolt remover Removal and installation of disc & hub assembly ...

Copyright © www.ksmanual.com 2014-2021