1. |
Remove the rear roof trim.
(Refer to Body - "Roof Trim Assembly")
|
2. |
Disconnect the power cable (A).
|
3. |
Disconnect the connectors (A) from the roof antenna.
|
4. |
Remove the roof antenna (B) after removing a nut (A).
|
TPMS Sensor Description
1.
Mode
(1)
Configuration State
A.
All sensors should be in the Low Line state.
...
Ignition Coil Installation
1.
Install in the reverse order of removal.
Ignition coil installation bolts:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
...
Transaxle Control Module (TCM) Installation
When replacing the TCM, the vehicle equipped with the immobilizer
must be performed procedure as below.
[In the ...