Kia Sorento: Rear Shock Absorber Installation - Rear Suspension System - Suspension System - Kia Sorento XM 2011-2020 Service ManualKia Sorento: Rear Shock Absorber Installation

Second Generation XM (2011-2020) / Kia Sorento XM 2011-2020 Service Manual / Suspension System / Rear Suspension System / Rear Shock Absorber Installation

1.
Installation is the reverse of removal.
  
After checking the distance 454±10mm (17.8740±0.3937 in.) between the wheel housing garnish (A) and the hub assembly (B) as shown in the illustration, tighten the mounting bolts and nuts of rear chassis part with specified torque.

Rear Shock Absorber Inspection
1. Check the rubber parts for damage or deterioration. 2. Check the shock absorber for abnormal resistance or unusual sounds. ...

Rear Upper Arm Removal
1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) ...

See also:

Piston and Connecting Rod Inspection
Connecting Rod 1. Check the connecting rod end play. Using a feeler gauge, measure the end play while moving the connecting rod back and forth. ...

Transaxle Control Module (TCM) Removal
   When replacing the TCM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the ...

Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

Copyright © www.ksmanual.com 2014-2020