Kia Sorento: Rear Lower Arm Removal
Second Generation XM (2011-2025) / Kia Sorento XM 2011-2025 Service Manual / Suspension System / Rear Suspension System / Rear Lower Arm Removal
| 1. |
Remove the rear wheel and tire (A) from rear hub .
|
| 2. |
Support the rear lower arm (A) with a jack as shown in the illustration.
|
| 3. |
Loosen the bolt & nut and then remove the rear lower arm (A) with
the rear axle.
|
| 4. |
Loosen the bolt & nut and then remove the rear lower arm (B) with
the sub frame (A).
|
| 5. |
Installation is the reverse of removal.
|
| 6. |
Check the wheel Alignment.
(Refer to Tires/Wheels - "Alignment")
|
Rear Upper Arm Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the rear upper arm or damage and deformation.
3.
...
Rear Lower Arm Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the rear lower arm for deformation.
...
See also:
Inspection
[Evap Leak Test]
Engine Control Module (ECM) controls Purge Control Solenoid Valve (PCSV)
and Canister Close Valve (CCV) for EVAP System diagnosis if the conditions are
satisfied ...
Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
IMS Control Switch Inspection
1.
Disconnect the IMS control switch connector.
2.
With the power IMS control switch in each position, make sure
that continuity ex ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright www.ksmanual.com 2014-2025