Kia Sorento: Parking Brake Lever Assembly Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Brake System / Parking Brake System / Parking Brake Lever Assembly Removal
The parking brake cables must not be bent or distorted. This will
lead to stiff operation and premature failure.
|
| 1. |
Remove the floor console assembly.
(Refer to Body - "Floor console")
|
| 2. |
Disconnect the connector (A) of parking brake switch.
|
| 3. |
Loosen the adjusting nut (A) and the parking brake cables (B).
|
| 4. |
Remove the parking brake lever assembly (A) after removing the
bolts.
|
Parking Brake Assembly Installation
Parking Brake Shoe
1.
Install the shoe hold down pin (A) and spring (B) by pressing
and rotating the spring.
2.
Install the ope ...
Parking Brake Lever Assembly Installation
1.
Install the parking brake lever assembly (A).
Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
...
See also:
Auto Defogging Actuator Description
The auto defogging sensor is installed on front window glass. The sensor
judges and sends signal if moisture occurs to blow out wind for defogging. The
air conditioner control module receives ...
Transaxle Control Module (TCM) Description
Transaxle Control Module (TCM) is the automatic transaxle's brain. The
module receives and processes signals from various sensors and implements a
wide range of transaxle controls to ensu ...
Driver Airbag (DAB) Module and Clock Spring Inspection
Driver Airbag (DAB)
If any improper parts are found during the following inspection, replace
the airbag module with a new one.
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026