Kia Sorento: Oil Level Gauge & Pipe Removal and Installation - Lubrication System - Engine Mechanical System - Kia Sorento XM 2011-2021 Service ManualKia Sorento: Oil Level Gauge & Pipe Removal and Installation

Second Generation XM (2011-2021) / Kia Sorento XM 2011-2021 Service Manual / Engine Mechanical System / Lubrication System / Oil Level Gauge & Pipe Removal and Installation

1.
Remove the oil gauge(A).

2.
Remove the intake manofold.
(Refer to Intake And Exhaust System - "Intake Manifold")
3.
Remove the oil level pipe(A).

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

4.
Install in the reverse order of removal.
Oil Pressure Switch Inspection
1. Check the continuity between the terminal and the body with an ohmmeter. If there is no continuity, replace the oil pressure switch. 2. ...

Intake And Exhaust System
...

See also:

Rear Blower Unit Replacement
1. Disconnect the negative (-) battery terminal. 2. Recover the refrigerant with a recover/recycling/charging station. 3. ...

Setup
Display Settings Press the key Select [Display] through TUNE knob or key Select menu through TUNE knob Mode Pop up [Mode Pop up]   Changes selection mode During On state, pr ...

Parking Brake Assembly Removal
Parking Brake Shoe 1. Raise the vehicle, and make sure it is securely supported. 2. Remove the rear tire and wheel. 3. ...

Copyright © www.ksmanual.com 2014-2021