Kia Sorento: Oil Cooler Removal - Lubrication System - Engine Mechanical System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Oil Cooler Removal

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Engine Mechanical System / Lubrication System / Oil Cooler Removal

1.
Loosen the drain plug, and drain the coolant. Remove the radiator cap to help drain the coolant faster.
2.
Disconnect the oil cooler coolant hoses (A).

3.
Using the SST (09263-2E000), remove the oil filter (A).

4.
Loosen the mounting bolt (A) and remove the oil cooler assembly (B).

Engine Oil Inspection
1. Check the engine oil quality. Check the oil deterioration, entry of water, discoloring of thinning. If the quality is visibly poor, replace the oil. ...

Oil Cooler Installation
1. Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler with fix bolt (B). Tightening torque: ...

See also:

Tilting the sunroof
Before opening or closing the sunroof, open the roller blind (refer to the following page for instructions on how to use the roller blind). To open the sunroof, push the sunroof control lever upwa ...

Evaporator Temperature Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater - "Heater Unit") ...

Compressor Removal
1. If the compressor is marginally operable, run the engine at idle speed, and let the air conditioning work for a few minutes, then shut the engine off. ...

Copyright © www.ksmanual.com 2014-2019