Kia Sorento: Installation - Torque Converter Control Solenoid Valve (T/CON_VFS) - Automatic Transaxle Control System - Automatic Transaxle System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Installation

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS) / Installation

1.
Install in the reverse order of removal.
  
Х
Adding coolant.
(Refer to Engine Mechanical System - "Coolant")
Х
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
Х
Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
Removal
1. Remove the air duct. (Refer to Engine Mechanical System - "Air cleaner") 2. Remove the battery and the battery tray. ...

26 Brake Control Solenoid Valve(26/B_VFS)
26Brake control solenoid valve(26/B) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 26Brake. ...

See also:

Parking Assist Sensor Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the rear bumper cover. (Refer to Body - "Rear Bumper Cover") ...

Troubleshooting
Symptom Suspect Area Remedy (Refer to page) Water leaks from panorama sunroof Deteriorated roof lid weatherstrip Replace Excessive roof lid ...

Side Airbag (SAB) Module Description
The Side Airbags (SAB) are installed inside the front seat and protects the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of side airbag by using Si ...

Copyright © www.ksmanual.com 2014-2019