Kia Sorento: Installation - Accelerator Position Sensor (APS) - Engine Control System - Engine Control / Fuel System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) / Installation

1.
Install in the reverse order of removal.

Accelerator pedal module installation nut:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)
Accelerator pedal module installation bolt:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

Removal
1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). ...

Fuel Tank Pressure Sensor (FTPS)
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge control solen ...

See also:

Mirror Replacement
Outside Rear View Mirror Assembly Replacement    • When prying with a flat-up screwdriver, w ...

Reservoir Tank Removal and Installation
1. Remove the over flow hose(A). 2. Remove the reservoir tank(B) after loosening the bolts. Tightening torque: ...

Front Strut Assembly Disassembly
1. Remove the dust cover(A). 2. Using the special tool (09546-26000), compress the coil spring (A). 3. ...

Copyright www.ksmanual.com 2014-2026