Kia Sorento: Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. If the component has been dropped, inspect before
installing.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
|
1. |
Install in the reverse order of removal.
Manifold absolute pressure sensor
installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the manifold absolute pressure sensor connecto ...
See also:
SRS Control Module (SRSCM) Variant coding
After replacing the SRSCM with a new one, MUST perform the “Variant Coding”
procedure.
1.
...
Engine compartment
1. Engine coolant reservoir
2. Engine oil filler cap
3. Brake/clutch fluid reservoir
4. Air cleaner
5. Fuse box
6. Negative battery terminal
7. Positive battery terminal
8. Radiator cap
9. E ...
Auto Defogging Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the auto defogging sensor cover (A).
3.
Disconnect t ...
Removal
