1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the VIS valve connector.
|
3. |
Measure resistance between VIS valve terminals 1 and 2.
|
Troubleshooting
Problem Symptoms Table
Use the table below to help you find the cause of the problem. The numbers
indicate the priority of the like cause of the problem. Check each part in order.
...
Drive Belt Inspection
1.
Visually check the belt for excessive wear, frayed cords etc.
If any defect has been found, replace the drive belt.
  ...
Installation
•
Install the component with the specified torques.
•
...