Kia Sorento: Inspection
| 1. |
Disconnect the ignition switch connector (B) and key warning switch
connector (A) from under the steering column.
|
| 2. |
Check for continuity between the terminals.
|
| 3. |
If continuity is not specified, replace the switch.
|
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds.
(Refer to Steering System - &quo ...
See also:
Accelerator Position Sensor (APS)
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS is one
of the most important sensors in engine ...
Front Driveshaft Components
1. Front driveshaft (LH)
2. Inner shaft bearing bracket
3. Front driveshaft (RH)
[LH]
1. BJ assembly
2. Clip
3. BJ boot band
4. BJ bo ...
Engine Room Under Cover Removal and Installation
1.
Unfasten the fasteners and bolts and then remove the engine room under
cover (A).
Tightening torque:
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf ...
Copyright В© www.ksmanual.com 2014-2024