Kia Sorento: Direct Electro Hydraulic Actuator Coupling Installation - Coupling Assembly - 4 Wheel Drive (4WD) System - Kia Sorento XM 2011-2019 Service ManualKia Sorento: Direct Electro Hydraulic Actuator Coupling Installation

Second Generation XM (2011-2019) / Kia Sorento XM 2011-2019 Service Manual / 4 Wheel Drive (4WD) System / Coupling Assembly / Direct Electro Hydraulic Actuator Coupling Installation

1.
Install in the reverse order of removal.
  
Х
Smear the splines (A) with molybdenum type high pressure grease.
Х
When install the coupling, be careful not to damage the oil seal (B).

2.
After replacing the coupling, reset the 4WD ECU's clutch learing using the GDS tool.
(Refer to 4WD Control System - "Repair procedures")
Direct Electro Hydraulic Actuator Coupling Removal
   Coupling Maintenance Precautions Maintain the coupling at a horizontal level. Х ...

Oil hydraulic Motor(Actuator) Description
The 4WD ECM controls the Pump Motor Pump (Actuator) to generating an oil pressure. The pressure engages a multiple disk clutch to transfer torque to the rear wheels. The torque to the rear wh ...

See also:

Good driving practices
Never move the gear shift lever from P (Park) to any other position with the accelerator pedal depressed. Never move the gear shift lever into P (Park) when the vehicle is in motion. Be sure ...

[CVVT System Mode]
(1) Low Speed / Low Load (2) Part Load (3) Low Speed / High Load (4) High Speed / High Load ...

Heated Oxygen Sensor (HO2S)
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed both upstream and downstream of the Manifold Catalytic Converter. The sensor output voltage varies in accordance ...

Copyright © www.ksmanual.com 2014-2019