Kia Sorento: Front Body E
| * These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Hood hinge mounting hole (Ø11) |
Fender apron upper panel corner |
Fender apron upper panel tooling hole (7X12) |
|
|
|
|
| Fender panel mounting hole (Ø9) |
Front shock absorber mounting hole (Ø13) |
Cowl panel tooling hole (Ø6.6) |
|
|
|
|
| Front pillar outer corner |
Front pillar outer corner |
Engine mounting bracket hole (Ø13) |
|
|
|
|
| Transaxle mounting hole (Ø15) |
Engine mounting bracket hole (Ø13) |
Transaxle mounting hole (Ø15) |
|
|
|
|
| Front side member tooling hole (Ø11) |
Front side member tooling hole (Ø11) |
Front end module mounting hole (Ø13) |
|
|
||
| Front end module mounting hole (Ø9) |
Front Body D
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
Side Body A
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
...
See also:
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the HO2S connector.
3.
Measure resistance between the HO2S termi ...
Rear Wheel Speed Sensor Removal
4WD only
1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
...
Installation
•
Install the component with the specified torques.
•
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026