Kia Sorento: Yaw-rate and G Sensor Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Brake System / ESC(Electronic Stability Control) System / Yaw-rate and G Sensor Removal
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 3. |
Remove the floor console.
(Refer to Body - "Floor console")
|
| 4. |
Loosen the bolts and then remove the rear air vent duct (A).
|
| 5. |
Pull up the lock, of the SRSCM connector, the disconnect the connector
(A).
|
| 6. |
Remove the SRSCM mounting bolts (3EA) from the SRSCM, then remove
the SRSCM.
|
You must remove or install SRSCM or other SRS components with
the ignition swich OFF to avoid accidental airbag deployment.
|
Yaw-rate and G Sensor Description
The yaw rate and G sensor is included inside the air bag control module
(SRSCM).
When the vehicle is turning with respect to a vertical axis the yaw rate
sensor detects the yaw rate elec ...
Yaw-rate and G Sensor Installation
1.
Remove the ignition key from the vehicle.
2.
Install inthe reverse order of removal.
3.
After installing the ...
See also:
High Pressure Fuel Pump Installation
•
Be sure to check the low pressure fuel hose quick-connector
(A) is completely connec ...
Master Cylinder Components
1. Reservoir cap
2. Reservoir
3. Grommet
4. Master cylinder
...
Piston and Connecting Rod Reassembly
•
Thoroughly clean all parts to be assembled.
•
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026