Kia Optima Manuals

Kia Sorento: Front Disc Brake Inspection - Brake System - Brake System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Front Disc Brake Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Brake System / Brake System / Front Disc Brake Inspection

Front brake disc thickness check
1.
Check the brake pads for wear and fade.
2.
Check the brake disc for damage and cracks.
3.
Remove all rust and contamination from the surface, and measure the disc thickness at 8 points, at least, of same distance (5mm) from the brake disc outer circle.
Front brake disc thickness
- Standard : 28 mm (1.10 in)
- Service limit : 26 mm (1.02 in)
- Deviation : Less than 0.005 mm (0.0002 in)

4.
If wear exceeds the limit, replace the discs and pad assembly left and right of the vehicle.
Front Brake Pad Check
1.
Check the pad wear. Measure the pad thickness and replace it, if it is less than the specified value.
Pad thickness
Standard value: 11 mm (0.43 in)
Service limit: 2.0 mm (0.0787 in)
2.
Check that grease is applied, to sliding contact points and the pad and backing metal for damage.
Front brake disc runout check
1.
Place a dial gauge about 5mm (0.2 in.) from the outer circumference of the brake disc, and measure the runout of the disc.
Brake disc runout
Limit: 0.025 mm (0.00098 in.) or less (new one)

2.
If the runout of the brake disc exceeds the limit specification, replace the disc, and then measure the runout again.
3.
If the runout does not exceed the limit specification, install the brake disc after turning it 180° and then check the runout of the brake disc again.
4.
If the runout cannot be corrected by changing the position of the brake disc, replace the brake disc.
Front Disc Brake Replacement
Front brake pads 1. Loosen the guide rod bolt (B) and then remove caliper body (A). 2. Replace pad shim (D), pad retainers (C) and b ...

Front Disc Brake Installation
1. Installation is the reverse of removal. 2. Compress the piston into the caliper body using the SST (09581-11000). ...

See also:

Valve Body Removal
1. Remove the air duct. (Refer to Engine Mechanical System - "Air cleaner") 2. Remove the battery and the battery tray. ...

Thermostat Troubleshooting
Symptoms Possible Causes Remedy Coolant leakage • From the thermostat gasket Check the mounting bolts ...

Specification
Pressure [kPa (kgf/cm², in H2O) Output Voltage (V) -3.75 (-0.038, -15.05) 4.5 0 1.5 +1.25 (0.013, 5.02) 0.5 ...

Categories

Copyright www.ksmanual.com 2014-2026