Kia Optima Manuals

Kia Sorento: Driver Airbag (DAB) Module and Clock Spring Installation - Airbag Module - Restraint - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Driver Airbag (DAB) Module and Clock Spring Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Restraint / Airbag Module / Driver Airbag (DAB) Module and Clock Spring Installation

1.
Set the front tires straight-ahead before assembling the steering wheel.
  
If the steering wheel and the front tires are not set straight ahead together, it affects the number of revolutions of steering wheel and the cable inside the clock spring is possible to be damaged.
2.
Disconnect the battery negative cable.
  
After disconnecting the battery negative cable, wait for at least thirty seconds.
3.
Set the clock spring in center before assembling it to a steering wheel.
(1)
Turn the clock spring clockwise to the stop.
(2)
3 revolutions counterclockwise and make sure to set an array the mark (▶◀).
(In the case of 18ch heating wire, 2 revolutions counterclockwise)
(Once the mark (▶◀) is set an array, the clock spring is automatically locked.)
4.
Connect the clock spring harness connector and horn harness connector to the clock spring.
5.
Install the steering wheel column cover and the steering wheel. (Refer to the Steering System group- Steering Column and Shaft)
6.
Connect the Driver Airbag (DAB) module connector, and then install the Driver Airbag (DAB) module on the steering wheel.
7.
Secure the Driver Airbag (DAB) with the new mounting bolts.
Tightening torque :
7.8 ~ 10.8 Nm (0.8 ~ 1.1 kgf.m, 5.8 ~ 8.0 lb.ft)
8.
Connect the battery negative cable.
9.
After installing the airbag, confirm proper system operation:
  
-
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
-
Make sure horn works.
Driver Airbag (DAB) Module and Clock Spring Inspection
Driver Airbag (DAB) If any improper parts are found during the following inspection, replace the airbag module with a new one.    ...

Passenger Airbag (PAB) Module Description
Passenger Airbag (PAB) module is located in the passenger crash pad. This PAB contains 2 firing squibs of airbag and 1 firing squib of active vent. Depending of crash speed or the tightening ...

See also:

Water pump Removal and Installation
1. Loosen the drain plug, and then drain the engine coolant. Remove the radiator cap to help drain the coolant faster. 2. Remove the dr ...

Sound settings
Press the key Select [Sound] through TUNE knob or key Select menu through TUNE knob   Sound Settings This menu allows you to set the ‘Bass, Middle, Treble’ and the Sound Fader ...

Circuit Diagram
...

Categories

Copyright www.ksmanual.com 2014-2026