Kia Sorento: Side Impact Sensor (SIS) Description - SRSCM - Restraint - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Side Impact Sensor (SIS) Description

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) Description

Side Impact Sensor (SIS) system consists of two Front-SIS which are installed at each center of the front door module (LH and RH) and two Rear-SIS which are installed at each rear pillar nearby (LH and RH).
Front-Side Impact Sensor (F-SIS) is also called P-SIS because that detects pressure due to collision at its mounting location.
Rear-Side Impact Sensor (R-SIS) is also called A-SIS because that detects acceleration.
SRSCM decides deployment or not of the airbag and the time of deployment through the collision signal of SIS when the collision occurred.
Front Impact Sensor (FIS) Installation
   • Do not turn the ignition switch ON and do not contact the battery cable while replac ...

Side Impact Sensor (SIS) Components
...

See also:

Output Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification : Refer to "Signal Wave Form" section. ...

IMS module Installation
1. Install the IMS module after reconnecting the connector. 2. Install the driver seat.    ...

Precautions
General Precautions Please read the following precautions carefully before performing the airbag system service. Observe the instructions described in this manual, or the airba ...

Copyright www.ksmanual.com 2014-2026