Kia Sorento: SRS Control Module (SRSCM) Removal - SRSCM - Restraint - Kia Sorento XM 2011-2026 Service ManualKia Sorento: SRS Control Module (SRSCM) Removal

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Restraint / SRSCM / SRS Control Module (SRSCM) Removal

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes before beginning work.
3.
Remove the floor console.
(Refer to Body - "Floor console")
4.
Loosen the bolts and then remove the rear air vent duct (A).

5.
Pull up the lock of the SRSCM connector, the disconnect the connector (A).

6.
Remove the SRSCM mounting bolts(3EA) from the SRSCM, then remove the SRSCM.
  
You must remove or install SRSCM or other SRS components with the ignition swich OFF to avoid accidental airbag deployment.
SRS Control Module (SRSCM) Components
...

SRS Control Module (SRSCM) Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning ...

See also:

Engine Oil Inspection
1. Check the engine oil quality. Check the oil deterioration, entry of water, discoloring of thinning. If the quality is visibly poor, replace the oil. ...

Rear combination lamp Removal
1. Disconnect the negative (-) battery terminal. [Outside] 2. Loose the screws (2EA) holding the rear combination lamp then disconn ...

Battery Vehicle parasitic current inspection
1. Turn the all electric devices OFF, and then turn the ignition switch OFF. 2. Close all doors except the engine hood, and then lock all d ...

Copyright www.ksmanual.com 2014-2026