Kia Sorento: TPMS Receiver Replacement
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Receiver Replacement
When the receiver first arrives for replacement:
|
It is important to make sure that the correct receiver is used
to replace the faulty part i.e. it must be Low Line (95800-1U00) in
order to have the correct inflation warning thresholds set.
|
| 1. |
Disconnect vehicle battery (-)cable.
|
| 2. |
Remove the glove box housing.
(Refer to Body - "Glove Box Housing")
|
| 3. |
Remove faulty part and fit bracket assembly to new part.
|
| 4. |
Secure new part to vehicle and fit connector.
|
| 5. |
Re-connect battery and turn Ignition on.
Vechicle Name Writing
VIN Writing
|
TPMS Receiver Operation
1.
General Function
A.
Auto learn takes place only once per Ignition cycle.
B.
On successful compl ...
Steering System
...
See also:
Pressure Sensor Description
The 4WD ECU makes a Motor Pump(Actuator) turn round for generating an
oil pressure. And then it presses a multiple disk clutch and transfers the generated
torque into rear wheels. Its torque ...
Blower Resistor Inspection
1.
Measure the resistance between the terminals.
2.
The measured resistance is not within specification, the blower
resistor must be replac ...
Under Body (2WD)
Projected Dimensions
* These dimensions indicated in this figure are actual-measurement
dimensions. [ Unit : mm (inch) ]
Actual-Measurement Dimensions
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026