Kia Sorento: Wheel Hub nut tightening sequence
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Suspension System / Tires/Wheels / Wheel Hub nut tightening sequence
Tighten the hub nuts as follows.
Tightening torque:
88.3 ~ 107.9N.m (9.0 ~ 11.0kgf.m, 65.1 ~ 79.6lb-ft)
|
When using an impact gun, final tightening torque should be checked
using a torque wrench.
|
Run out inspection
| 1. |
Jack up the vehicle.
|
| 2. |
Measure the wheel Run-out by using a dial indicator as illustration
below.
|
| 3. |
If measured value exceeds the standard value, replace the wheel.
|
Tire Installation
1.
Apply tire soap or lubrication to the top and bottom tire beads.
2.
To fit the bottom bead, position the valve at the 5 o’clock pos ...
Front wheel alignment
When using a commercially available computerized wheel alignment
equipment to inspect the front wheel alignment, always ...
See also:
Rear Wiper Motor Removal
1.
Detach the rear wiper cap (A).
2.
Remove the rear wiper arm & blade (A) after removing rear wiper
HEX nut (B).
...
Component Location
1. Panorama sunroof (Panorama)
2. Panorama sunroof switch
3. Panorama sunroof motor & controller (Master)
4. Roller blind motor & controller (Slave)
...
Front Strut Assembly Reassembly
1.
Install the spring lower pad (D) so that the protrusions(A) fit
in the holes (C) in the spring lower seat (B).
2.
Compress coil ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026