Kia Sorento: TJ Joint Installation
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Driveshaft and axle / Driveshaft Assembly / TJ Joint Installation
| 1. |
Wrap tape around the driveshaft spline(TJ) to prevent damage to
the boot.
|
| 2. |
Using the alignment marks (D) made during disassembly as a guide,
install the spider assembly (A) and retainer ring (B) on the driveshaft
splines (C).
|
| 3. |
Add specified grease to the joint boot as much as it was wiped
away at inspection.
|
| 4. |
Install the both boot band.
|
| 5. |
Using the SST(09495-3K000), secure the TJ boot bands.
|
| 6. |
Install the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
|
TJ Joint Inspection
1.
Check the spider assembly for roller rotation, wear or corrosion.
2.
Check the groove inside the joint case for wear or corrosion
...
Dynamic Damper Components
1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
...
See also:
Tilt and telescopic steering
Tilt and telescopic steering allows you to adjust the steering wheel before you
drive.You can also raise it to give your legs more room when you exit and enter
the vehicle.
The steering wheel shoul ...
Radiator Removal and Installation
1.
Disconnect the battery terminals.
2.
Remove the air cleaner assembly.
(Refer to Intake And Exhaust System - "Air Cleaner" ...
Specification
Pressure
[kPa (kgf/cm², psi)]
Output Voltage (V)
20.0 (0.20, 2.9)
0.79
46.7 (0.47, 6.77)
1.84
101.3 (1.03, 14.7)
4.0
...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026