Kia Sorento: TJ Joint Inspection - Driveshaft Assembly - Driveshaft and axle - Kia Sorento XM 2011-2026 Service ManualKia Sorento: TJ Joint Inspection

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Driveshaft and axle / Driveshaft Assembly / TJ Joint Inspection

1.
Check the spider assembly for roller rotation, wear or corrosion.
2.
Check the groove inside the joint case for wear or corrosion
3.
Check the TJ boots for damage and deterioration.
TJ Joint Removal
   • Special grease must be applied to the driveshaft joint. Do not substitute with anoth ...

TJ Joint Installation
1. Wrap tape around the driveshaft spline(TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...

See also:

Emergency Fastening Device (EFD) Description
Emergency Fastening Device (EFD) operates as well as Belt Pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on driver and pass ...

Air bag
(1) Driver’s front air bag (2) Passenger’s front air bag (3) Side air bag (4) Curtain air bag WARNING Even in vehicles with air bags, you and your passengers must always wear the safety be ...

Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the engine may stop ...

Copyright www.ksmanual.com 2014-2026