1. |
Install in the reverse order of removal.
|
2. |
Prior to installing a new ECU, upload the original ECU’s clutch
learing to the replacement ECU using the GDS tool.
(Refer to 4WD Control System - "Repair procedures")
|
Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TP ...
Overhead Console Lamp Inspection
Remove the overhead console lamp assembly then check for continuity between
terminals. If the continuity is not as specified, replace the map lamp switch.
...