Kia Sorento: Front Wheel Transfer Assembly Installation

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / 4 Wheel Drive (4WD) System / Transfer Assembly / Front Wheel Transfer Assembly Installation

1.

Install in the reverse order of removal.

1.	Be careful not to damage the O-ring (A). If the O-ring is damaged, replace with a new one.

2.

Smear and cover splines (B) with molybdenum type high pressure grease.

TECHLUBE MEGAMAX - ALPHA or equivalent

3.	Install the propeller shaft to be near runout marking (Transfer assembly 1ea, propeller shaft 1ea) each other.

Front Wheel Transfer Assembly Removal

It is not recommended to overhaul the transfer assembly because a special three-dimensional measuring instrument is requ ...

Oil Seal Replacement

[Right side] 1. Remove the front muffler. (Only gasoline 3.3) (Refer to Engine Mechanical System - "Front Muffler ") 2. Re ...

See also:

Cowl Top Cover Replacement
1. Remove the cap (A) and remove the nuts, then remove the wiper arm (B). Tightening torque : 22.6 ~ 26.5 N.m(2.3 ~ 2.7 kgf.m, 16.6 ~ ...

Maintenance service
You should exercise the utmost care to prevent damage to your vehicle and injury to yourself whenever performing any maintenance or inspection procedures. Should you have any doubts concerning the i ...

Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the manifold absolute pressure sensor connecto ...

Categories

Copyright © www.ksmanual.com 2014-2026