Kia Optima Manuals

Kia Sorento: Transfer Fluid Replacement - Transfer Assembly - 4 Wheel Drive (4WD) System - Kia Sorento XM 2011-2026 Service ManualKia Sorento: Transfer Fluid Replacement

Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / 4 Wheel Drive (4WD) System / Transfer Assembly / Transfer Fluid Replacement

  
Change
Normal Use
 Severe Use
No service required
 120,000 km
(80,000 miles)

Severe driving conditions
1.
Driving in dusty, rough roads
2.
Drivng in mountains areas
3.
Driving for patrol car, taxi, commercial car or vehicle towing
4.
Driving over 170Km/h
* Transfer oil should be replaced if the transfer assembly is fall into the water.
1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Drain the transfer oil after loosening the drain plug (A).
3.
Install the drain plug with new gasket.
Tightening torque :
58.9 ~ 78.5 N.m (6.0 ~ 8.0 kgf.m, 43.4 ~ 57.9 lb-ft)
4.
Remove the oil filler plug (A).
[Gasoline 2.4]

[Gasoline 3.3]
5.
Add new oil through the filler plug hole.
Standard oil :
Hypoid gear oil, MS 517-I5 GT
(SAE 75W/90, API GL-5, SHELL SPIRAX X or equivalent)
Oil capacity :
Gasoline 2.4: About 0.6 L (0.16 U.S.gal., 0.63 U.S.qt, 0.53 Imp.qt.)
Gasoline 3.3: About 0.68 L(0.18 U.S.gal, 0.72 U.S.qt, 0.60 lmp,qt)
  
•
Filled up to lower filler plug thread level.

6.
Install the oil filler plug with new gasket.
Tightening torque :
39.2 ~ 58.8 N.m (4.0 ~ 6.0 kgf.m, 28.9 ~ 43.4 lb-ft)
7.
Install the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
Transfer Fluid Inspection
   • Transfer oil should be inspected and refilled every 60000 km (40000 mile) / 4 year. ...

Front Wheel Transfer Assembly Components Location
1. Under cover 2. Transaxle Assembly 3. Transfer assembly 4. Propeller shaft 5. Coupling assembly 1. Under cover 2. Transaxle Assembly 3 ...

See also:

Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two Front-SIS which are installed at each center of the front door module (LH and RH) and two Rear-SIS which are installed at each rear pillar near ...

Seats
Front seat (1) Forward and backward (2) Seatback angle (3) Seat cushion height (Driver’s seat) (4) Lumbar support (Driver’s seat) (5) Seat warmer /Seat cooler (Air ventilation seat) (6) H ...

Front Oil Seal Removal and Installation
1. Remove the crankshaft damper pulley. (Refer to Timing System - "Crankshaft Damper Pullty") 2. Remove the front oil seal(A). ...

Categories

Copyright www.ksmanual.com 2014-2026