Kia Sorento: Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the hydraulic pressure
will need to be adjusted after replacing the VFS solenoid valve. If
replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
|
Inspection
1.
Turn ignition switch OFF.
2.
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
...
35R Clutch Control Solenoid Valve(35R/C_VFS)
35R Clutch control solenoid valve(35R/C) is attached to the valve body.
This variable force solenoid valve directly controls the hydraulic pressure
inside the 35R Clutch.
...
See also:
General Troubleshooting Information
Before Troubleshooting
1.
Check applicable fuses in the appropriate fuse/relay box.
2.
Using the battery checker (MCR-570 KIT), check the ba ...
Timing Chain Installation
1.
Install the balance shaft chain.
(Refer to Lubrication system - "Balance Shaft & Oil Pump")
2.
Install the crankshaft ...
Blower Unit Components
1. Intake Case (LH)
2. Intake Case (RH)
3. Intake Door
4. Cowl Seal
5. NVH Seal
6. Blower Upper Case
7. Cluster Ionizer
8. Blower Lower Case
9. Power Mosfet (DAT ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2025 Owners Manual
- Kia Sorento XM 2011-2025 Service Manual
Copyright www.ksmanual.com 2014-2025