1. |
Turn ignition switch OFF.
|
2. |
Remove the air duct.
(Refer to Engine Mechanical System - "Air cleaner")
|
3. |
Disconnect the solenoid valve connector (A).
|
4. |
Measure resistance between sensor signal terminal and sensor ground
terminal.
|
5. |
Check that the resistance is within the specification.
|
Cylinder Block Reassembly
1.
Install the oil jet (A).
Tightening torque :
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)
...
AUX(Auxiliary) Jack Removal
Put on gloves to protect your hands.
...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the steering column upper and lower shrouds.
(Refer to Steering System - &quo ...