Kia Sorento: Input Speed Sensor Removal
Second Generation XM (2011-2026) / Kia Sorento XM 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Input Speed Sensor Removal
| 1. |
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
|
| 2. |
Disconnect the input & output speed sensor connector (A).
|
| 3. |
Remove the input & output speed sensor (B) after removing the
bolts (2ea).
|
Input Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification :
Refer to "Signal Wave Form" section.
...
Input Speed Sensor Installation
1.
Install in the reverse order of removal.
•
...
See also:
Side Impact Sensor (SIS) Description
Side Impact Sensor (SIS) system consists of two Front-SIS which are installed
at each center of the front door module (LH and RH) and two Rear-SIS which are
installed at each rear pillar near ...
Cluster Ionizer Description
The cluster ionizer makes disinfection and decomposition of bad smell
from the air-conditioner or inflow air. And it cleans the inside air of a vehicle.
When the ignition switch is ON, the i ...
Power Tailgate Latch Inspection
Power Tailgate Inspection With GDS
1.
Check the power Tailgate module input/output value by using the
GDS. If the operation of power Tailgate module is abnormal, replac ...
Categories
- Home
- First Generation
- Second Generation
- Kia Sorento XM 2011-2026 Owners Manual
- Kia Sorento XM 2011-2026 Service Manual
Copyright www.ksmanual.com 2014-2026