Kia Sorento: Adjustment
Transaxle Control Module(TCM) Learning
When shift shock is occurred or parts related with the transaxle are replaced,
TCM learning should be performed.
In the following case, TCM learning is required.
| • |
Transaxle assembly replacement
|
| • |
TCM replacement
|
| • |
TCM upgrading
|
TCM learning procedure
| 1. |
Automatic Transaxle Fluid (ATF) temperature: 40 ~ 100°C (104 ~
212°F)
|
| 2. |
Static learning
Repeat the below shift pattern four times or more with stepping
on the brake.
|
| 3. |
Driving learning
Drive the vehicle from a stop in D through all gears 1st, 2nd,
3rd, 4th, 5th and 6th gear while holding the throttle steady at the
specified Throttle Position Sensor (TPS) value (15~25%).
|
Circuit Diagram
...
Transaxle Control Module (TCM) Description
Transaxle Control Module (TCM) is the automatic transaxle's brain. The
module receives and processes signals from various sensors and implements a
wide range of transaxle controls to ensu ...
See also:
Hazard Lamp Switch Installation
1.
Install the heater control unit to the center fascia panel.
2.
Install the center fascia panel.
...
Balance Shaft & Oil Pump Removal
BSM (Balance Shaft Module) Chain System
1.
Remove the timing chain.
(Refer to Timing System in this group)
2.
Install a stopper pin (A) ...
Fuel Tank Air Filter Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Lift the vehicle.
3.
D ...
Copyright © www.ksmanual.com 2014-2024