Kia Sorento: Tilting the sunroof

Before opening or closing the sunroof, open the roller blind (refer to the following page for instructions on how to use the roller blind).
To open the sunroof, push the sunroof control lever upward.
To close the sunroof, pull the sunroof lever downward or forward until the sunroof moves to the desired position.
WARNING - Sunroof
CAUTION
Sunshade

To open the sunshade
Press the sunshade open button (1).
To close the sunshade when the sunroof glass is closed
Press the sunshade close button (2).
❈ When you press the sunshade close button (2) with the sunroof glass opened, the sunshade will be closed halfway.
Push the sunroof control lever forward or pull it down.
To stop the sliding at any point, press the sunshade control switch momentarily.
✽ NOTICE
Wrinkles formed on the sunshade as material characteristic are normal.
CAUTION
Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, you must reset your sunroof system as follows:
1.Turn the ignition switch to the ON position.
2.Close the sunshade and sunroof completely if opened.
3.Release the sunroof control lever.
4.Push the sunroof control lever forward in the direction of close (about 10 seconds) until the sunroof moves a little. Then, release the lever.
5.Push the sunroof control lever forward in the direction of close, until the sunroof operates as follows again:
The sunshade and sunroof glass slide open → The sunroof glass slide close → The sunshade close Then, release the lever.
When this is complete, the sunroof system has been reset.
✽ NOTICE
If you do not reset the sunroof, it may not work properly.
Panoramic sunroof
Steering wheelCooling Fan Description
Control the cooling motor voltage in according to the duty(300Hz) of ECM.
[ECU → PWM Input Signal(SI : 300Hz)]
Signal Input Duty (%)
Motor Voltage (V)
10
...
Removal
In case of removing the high pressure fuel pump, high pressure
fuel pipe, delivery pipe, and injector, there may be inju ...
Ladder Frame Installation
1.
Apply liquid gasket to the mating surface of cylinder block and ladder
frame.
...